I made two pieces to hold each holo projector. One would be on the outside (where it would be seen) the other would be on the inside. I found some sticky felt pads that I placed on the inside of the holo projector holders.
The inside holder on the right still needs to be finished off. The felt pads will allow the holo projector to move.
Here the back and front holders are in place around the holo projector. They are held together by four 3mm bolts, one in each corner. I used a nut and a few washers to shim the two holders to the correct distance apart so that the holo projector moves nicely.
No comments:
Post a Comment